Chia Sẻ BMW có cần gạt nước ở kính chắn gió gặp sự cố phun nước

Discussion in 'Thông Cáo Báo Chí và Hướng Dẫn Sửa Chữa' started by v.chicken, Oct 9, 2017.

  1. v.chicken

    v.chicken Moderator

    Thông cáo báo chí: HÃNG BMW

    Thông cáo số: SI B61 01 09

    Dòng xe ( Model):

    - Tất cả dòng xe BMW

    - All

    Nội dung thông cáo ( Situation):

    - Thông cáo này dành cho dòng xe BMW có cần gạt nước ở kính chắn gió gặp sự cố phun nước rất ít thậm chí không có nước.

    - The windshield washer jets spray a very low volume of fluid or no fluid at all.

    Nguyên nhân ( Cause):


    - Do sự tích tụ tạp chất hoặc đóng tảo trong bộ lọc của cần gạt nước kính chắn gió, hoặc bộ lọc cần gạt nước bị hỏng.

    Situation 1

    A buildup of excess manufacturing-related materials on the windshield washer pump strainer. This primarily occurs on lower mileage vehicles.

    [NEW] Situation 2

    A buildup of an organic "algae-like" substance on the windshield washer pump strainer. The algaelike substance is typically caused by using only tap water in the washer fluid tank or using tap water with a diluted windshield washer concentrate mix.

    [NEW] Situation 3


    The windshield washer pump strainer is damaged because "incorrect type" of cleaning fluid use or one which contains an excessive and incorrect amount of washer fluid concentrate. This is not considered a warranty matter.

    Giải pháp (Correction):

    - Tháo bộ lọc ra kiểm tra và sửa chữa. Sau đó kiểm tra và xử lý chất lỏng theo đúng thể tích yêu cầu, chất lỏng nên sử dụng là nước cất.

    - 1. Remove the washer fluid pump per ISTA Repair Instruction 61 71 100 and inspect the strainer.


    - 2. Any remaining fluid in the washer fluid reservoir must be drained and properly discarded. Clean the reservoir tank as necessary.


    - 3. Replace the strainer, which is installed on the intake side of the pump, as required.


    - 4. Do not replace the washer pump, reservoir tank or windshield nozzles, provided they are still functioning properly. The washer pump can be tested using ISTA component activation in ECU functions.


    5. Refill the washer fluid reservoir with the allowable ratio of approved BMW Windshield Washer Concentrate and water (not tap water: recommended distilled water).
    Hướng dẫn khắc phục chi tiết bên dưới.
     

    Dowload Files:

    SI B 61 01 09.pdf

Share This Page